1.1. Section [CreationOptions(is3d)...] - Key "poolpath"

In the key poolpath, set the directory where all parts created by PARTsolutions shall be stored.


Default: Pool with subdirectories for standard and supplier catalogs (e.g. norm9, any_catalog_name.):


Prefixes in file name:


For projects that contain more than one prefix, these are automatically inserted into the file name with underscore as separator (e.g. Norm9, core hole)

Flat pool for standard and supplier catalogs:

Alternatively a flat pool without subdirectories can also be used: If desired, in this case the "directory name/catalog name" can be part of the file name, so that identical parts from different catalogs can be differentiated. On this compare under key "FileName".