2.3.5.1.  Block [CreationOptions(is3d)] - How to setup?
2.3.5.1.2.  Key "DistributeMass"
Prev  Next
2.3.5.1.2.  Key "DistributeMass"

Value range: 0/1

  • Value = 0:

    Do nothing

  • Value = 1:

    • If an assembly mass is given use it else calculate assembly mass from sub parts.

    • Calculate total assembly volume from subparts.

    • Get all non empty subparts.

    • For each non empty subpart:

      • Calculate subpart partial mass = ((subpart volume / volume of all subparts) * assembly mass)

      • Calculate subpart density = subpart partial mass / subpart volume

      • Assign calculated subpart density (instance only)

Prev Up Next
2.3.5.1.1.  Key "FileName" Home 2.3.5.1.3.  Key "EnhancedPhysicalProperties" - Calculation of Physical Properties