Under
Project selection, select the desired
directory.
Call the
context menu command Set QA status
-> Batch process set QA status.
-> The
same-named dialog box is opened.
In the dialog
box, on the left in the tree, select that projects and directories where
you want the changes to be applied.
->
Immediately after each change of selection, the display of Project path, Workflow and Information is changed (and accordingly
respective background color). The display under Workflow results from current and new QA
state, the display under Information as
well according to the specific combination of both.
Background colors:
Orange: QA
state can be changed, but the information must be considered.
(Published markup gets removed.)
Red: QA state
can NOT be changed. Reason is shown in the information.
Examples:
No
suitable "workflow" found.
The
parent element has to be adjusted, but cannot (because there is
no writing permission on the element, for example).
The
parent element always has to be adjusted, if its QA state is
higher than that of the child with the lowest one.
The
project is not in the SVN lock.
Green: Ok,
the intended action can be performed.
White: No
action necessary. (The current QA state equals the required QA
state.)
Font
color:
Indent: This option has no effect on the
functionality. When disabled, the project paths are shown without
indent.
Under
Affected projects, perform the desired
settings.
Click on the
button Execute batch.
-> The QA
state is adjusted accordingly.
-> The
information is updated according to the new situation. Optionally, you
can directly perform changes in the opened dialog again and execute
further batch runs.
Reset: The changes will be
cancelled.
OK: The changes are
confirmed and displayed under Project selection.
Save: The
changes are saved in PARTproject and can be
seen on the tabbed page History as
before when performing individual changes.
