1.1.1.3.2. PARTproject
1.1.1.3.2.1. Determine start project in Settings
Prev  Next
1.1.1.3.2.1. Determine start project in Settings

You can specify which path should be loaded when PARTproject is started.

To do this, click on Extras > Settings > General in PARTproject and enter the desired path in the input field under Load nodes automatically [Autoload Node]. You must then restart PARTproject for the changes to take effect.

Example:

D:/23d-libs/catalog/catalogname/subdirectory

Further information on the settings can be found here: Section 5.6.4.8.1, “ General ” in eCATALOG 3Dfindit.

Prev Up Next
1.1.1.3.2. PARTproject Home 1.1.1.3.2.2. Configuration files under CADENAS_SETUP encrypted