 |
As of V10 SP11 CAD data can be converted for a GeoSearch or LiveSearch via Remote Translation Service, on the fly centralized with Capvidia.[106]
This ensures that current CAD data and data already generated by Capvidia before have the same information content.
In order to set up the remote translation process the following steps are required:
Adjust partsol.cfg as the following figure shows.
$CADENAS_USER/psolopt.cfgor$CADENAS_DEFAULTUSER/psolopt.cfgThe described workflow requires the following setting: In block [CadAssistant], the key UseStepFormat has to be set on YES.
(STL as format is not possible.)
$CADENAS_SETUP/transremote.cfgAdjust transremote.cfg as the following figure shows.
Install PARTapplicationServer (PAPPSERVER) via command line.
$CADENAS\bin\x86\64\pappserver.exe –install
Start PARTapplicationServer (PAPPSERVER) via command line.
$CADENAS\bin\x86\64\pappserver.exe –start
In pappclient.cfg, add the respective IP address.
Install psworker service via command line.
Path..\bin\x86\64\psworker.exe –install
Start psworker GUI vial command line.
Path..\bin\x86\64\psworker.exe –gui
Open psworker config via command line and adjust the settings as shown in the following figures.
Path..\bin\x86\64\psworker.exe –config
Start PARTsolutionsWorker via command line or TaskManager-Services
Path..\bin\x86\64\psworker.exe –start
PARTapplicationserver and PARTsolutionsWorker should be running now.
